How tight are Johnny bolts? Use rubber washers inside the toilet tank and on the outside—between the toilet and any metal washers. Hand tighten the nuts on the tank bolts. Then, use a wrench to make a quarter-turn to tighten each nut. Remember, the purpose of the tank bolts are to create a good seal between tank and bowl.
Why does my toilet move when I sit? A rocking toilet can be caused by any number of issues, including a worn-out wax ring, a broken flange, broken flange bolts, or a sagging floor.
Should you put the wax ring on the toilet or the flange? Place the wax ring on the closet flange, not on the toilet. Pick up the toilet and set it evenly over the closet flange, making sure the bolts come through the bolt holes in the toilet base. Fine-tune the toilet position, so it’s right where you want it, then push it straight down so it smashes the wax evenly.
How do you hold toilet bolts in place?
How tight are Johnny bolts? – Related Questions
Why do toilet anchor bolts rust?
Moisture around the base of the toilet can corrode the anchor bolts. This moisture may be the result of water escaping from the toilet because of an imperfect seal or, in basements near sea level, it may come from condensation or poor drainage.
Should I caulk around the toilet?
Caulk keeps your toilet secure the floor, and avoids any chance of injury or toilet malfunctioning. It’s actually required by the International Plumbing Code to caulk a toilet to the floor, and now knowing the reasoning behind it, why would you not want to?
Is Johnny Bolt a villain?
For the comic character, see: Johnny Bolt. Johnny Bolt is a super crook. He wanted to be a superhero when he was a kid, but when he caused a huge accident which hurt a lot of people, he decided he would become a super villain. He stole in minor heists until Kasey told him to work for retiring.
How do you tighten Johnny bolts?
What is the point of a carriage bolt?
Carriage bolts are used to hold together wood with wood, wood with metal and even metal with metal. Their particular shape allows the bolt to be self-locking when placed through a square hole, especially when dealing with metal.
Should toilet bolts be loose?
This system is essential for correctly tightening the closet bolts that hold the toilet to the floor. A loose bolt can cause leaks, so it’s a good idea to carefully tighten toilet bolts once they begin to loosen.
How tight should you tighten bolts from tank to toilet?
Get the bolts snug but not tight. Some tanks have built in lugs that will contact the bowl. If yours has these, stop when they contact the bowl. You can fill the tank and look for leaks at the bolts.
How tight should toilet bolts be to floor?
As a rule of thumb, try a turn or two a side until you feel resistance, them try to wiggle the toilet bowl slightly. If there is no significant movement, you are probably tight enough. This tightening operation is a “feel” thing you get from experience, so be conservative and use your best judgement.
Should toilet be bolted to floor?
Closet (toilet) flanges must be 1/4″ above a finished floor. This is so the wax ring seals properly to the flange and the hub on the toilet. If a proper seal is not achieved it will result in leaking. If the flange is lower than or flush with the floor they make foam rings that cover the distance for a proper seal.
What are toilet bolts called?
Securing your toilet to the floor are two long bolts (called closet bolts) that come up through the base of the toilet and are secured with nuts.
